Panasonic KX-TGP600 - Tips on Making Calls; Receiving Calls

7
USER GUIDE
Panasonic DECT KX-TGP600 User Guide
Tips on Making Calls
• You can conrm that the number was dialed correctly before calling (Pre-dialing) by entering the number, then
KX-TPA60:
Press
. KX-TPA65:
O-hook
• To clear an entire number while pre-dialing, KX-TPA60:
Press
/[XFER/CLR] for more than 1 second.
KX-TPA65: Press
/[TRANSFER] for more than 1 second.
• If an outside call is received from a phone number stored in the Handset Phonebook, the number and name of the caller will be displayed in
the call log.
• To cancel dialing, press KX-TPA60:
KX-TPA65:
/[CANCEL]
• If
ashes, move closer to the base unit and dial again.
• To insert a 3 second pause between phone numbers, press
P *1.
It is useful when you want to operate voice mail service without listening to pre-recorded announcement, for example. Repeat as needed to
create longer pauses.
*1 This soft key is displayed only when congured on the telephone. Contact your administrator for further information.
Receiving Calls
• You can select the ringer for each type of incoming call. See “Incoming Option”, “Appendix A” on page 25.
• You can also use “Any Key Answer”*1, “Quick Answer”*1 or “Auto Answer” to answer a call. See “Answer Option”, “Appendix A” on page 25.
• The volume of the ringer can be adjusted, or turned o. See “Adjusting the Ringer Volume or Turning the Ringer O”, “Appendix A” on page
25.
• If you attach a headset before receiving an incoming call, and headset ringer is set to “On”, ringing will be heard from the headset.
• Please consider the following when “Quick Answer”*1 is set to “On”. If a brief power failure occurs when the handset is receiving a call on the
charger,
– if “Talk On Charger” is set to “O” (default), the call may be disconnected after being answered.
– if “Talk On Charger” is set to “On”, the call may be answered automatically. In this case, please note that privacy rights may be violated or
sensitive information may be transmitted to unauthorized parties.
• Note: To setup “Talk on Charger”, Use [MENU] → [ Tools] → [Talk Option] → [Talk on Charger] → On
*1 KX-TPA60 only.