/ /[HOLD]
To retrieve a call on hold at your line (when connected to the KX-TGP600 only)
1. /[LINE]
2. Press the dial key corresponding to the slowly flashing green LINE indicator, or
press [ ] or [ ] to select a slowly flashing green LINE indicator.
Holding in a System Parking Zone (Call Park)
You can use this feature as a transferring feature.
When Call Park is permitted, the "Call Park" item is available in the Function Key list.
However, the Call Park feature number must be set beforehand. Also, depending on your
phone system, you may need to enter a parking zone number to retrieve a parked call.
The feature depends on your phone system. Contact your administrator for further
information.
To set
1. KX-TPA60/KX-TPA65:
/[FUNC]/[FUNCTION] ("Call Park")
KX-TPA68:
Press the Program Key assigned as "Call Park".
To retrieve (Call Park Retrieve)
[In standby mode]
KX-TPA60/KX-TPA65:
1. Enter the Call Park Retrieve feature number.
2. KX-TPA60:
KX-TPA65: Off-hook
KX-TPA68:
1. Enter the Call Park Retrieve feature number.
2. Press the Program Key assigned as "Park Retrieve".
3. Off-hook.
Note
• Depending on the telephone system, the
/
soft key might blink to show
that the line has a parked call. In this case, you can retrieve the call by pressing the
blinking
/
soft key. However, to retrieve a parked call using the soft key,
the Call Park Retrieve feature number must be set beforehand. This item is displayed
only when it is enabled in settings. Contact your administrator for further information.
5.1.2 Holding a Call
99
To Next Page
Loading...
