9.4 Registering/Deregistering a Handset/Desk Phone to the
KX-TGP600
9.4.1 Registering a Handset/Desk Phone to the KX-TGP600
You can register a handset/desk phone to up to 4 base units.
You can register a base unit to up to 8 handsets/desk phones (KX-TPA60/KX-TPA65/
KX-TPA68/KX-UDT series
*1
).
There are 2 types of registration method.
• Handset/desk phone registration using the base unit
• Handset/desk phone registration using the handset/desk phone
The supplied handset/desk phone and base unit are preregistered. If for some reason
the handset/desk phone is not registered to the base unit (for example, the signal
strength is out of range even when the handset/desk phone is near the base unit), re-
register the handset/desk phone.
*1
KX-UDT series are not available for KX-TGP600LA, KX-TGP600LC,
KX-TGP600AG or KX-TGP600BR.
Note
You can perform a site survey of repeaters using an unregistered handset/desk phone
(KX-TPA60, KX-TPA65 and KX-TPA68 only) as follows:
1. Power on the unregistered handset/desk phone.
2. Press the [MON.] soft key.
3. Enter the site survey mode. Refer to the repeater Installation Manual for detailed
procedures.
4. To exit site survey mode, turn the handset/desk phone off and then on again.
Handset/desk phone registration using the base unit
When adding a new handset/desk phone:
1. Base unit:
a. Press and hold the handset locator button for about 3 seconds.
The STATUS indicator on the base unit will flash red (slow flashing).
2. Unregistered handset/desk phone:
[When adding a new handset/desk phone]
• Easy registration
In standby mode, press and hold
until displaying "Please Wait…".
After "Registered" displayed on the LCD, the registration is completed.
From step a to step d can be skipped.
[When registering a handset/desk phone to another base unit]
• Normal registration
[In standby mode]
9.4 Registering/Deregistering a Handset/Desk Phone to the KX-TGP600
138
To Next Page
Loading...
