Panasonic KX-TGP600G - Page 139

a. /
MENU
/
b. KX-TPA60/KX-TPA65:
[ ]/[ ]/[ ]/[ ]:
OK
KX-TPA68:
[ ]/[ ]: "Setting Handset"
OK
c. [ ]/[ ]: "System Option"
*1
OK
d. [ ]/[ ]: "Register H/S"
OK
e. Select a base unit.
OK
After "Registered" is displayed on the LCD, the registration is completed.
• If 4 base units have been registered to a handset/desk phone, "Memory Full" is
displayed on the LCD at step c.
*1
The administrator password may be required for this setting. Contact your
administrator for further information. For available characters, see 10.1.2 Character
Table for Administrator Password, page 146.
Handset/desk phone registration using the handset/desk phone
If operation using the base unit is difficult, or if you want to specify the handset/desk
phone number during registration, you can use a registered handset/desk phone to add
new handsets/desk phones.
Before operating the handset/desk phone, confirm that the STATUS indicator of the base
unit is Green (On/Slow Flashing/Quick Flashing).
1. Registered handset/desk phone:
[In standby mode]
a.
/
MENU
/
b. KX-TPA60/KX-TPA65:
[ ]/[ ]/[ ]/[ ]:
OK
KX-TPA68:
[
]/[ ]: "System Settings"
OK
c. [ ]/[ ]: "System Settings"
*1
OK
d. [ ]/[ ]: "Register H/S"
OK
e. Select a handset/desk phone.
OK
If more than 5 handsets/desk phones are registered, you can press
NEXT
/
to scroll down.
The STATUS indicator on the base unit will flash red (slow flashing).
2. Unregistered handset/desk phone:
9.4.1 Registering a Handset/Desk Phone to the KX-TGP600
139