1.1 Basic System Construction
Installation Manual 19
1.1.5 Installer Equipment and Software Requirements
The installer must use a PC and the KX-TVM/NCV Maintenance Console software to configure and
customise the VPS. The PC can be connected via the built-in USB port of the VPS, or can access the
VPS over a local network via the built-in LAN port (KX-TVM200/KX-NCV200) or an optional LAN
Interface Card (KX-TVM50). Off-site programming is also possible provided an optional Modem Card
is installed in the VPS.
For more information, see Section 3, Installing KX-TVM/NCV Maintenance Console.
To Next Page
Loading...
