Panasonic KX-TVM200 - Page 221

7.1 Initialising the VPS
Installation Manual 221
3. Click "OK".
4. Click "OK" to close all lines and continue with initialisation.
5. Click "OK" when system initialisation is complete.
Initialising the VPS with the Mode Switch
1.
Disconnect the port cables from the VPS.
2. Turn the power switch off at the VPS.
3. Set the Mode Switch to position 5.
4. Turn the power switch back on at the VPS.
5. Connect the port cables.
6. Confirm that the Run Indicator blinks 5 times.
7. Turn the power switch off at the VPS.
8. Set the Mode Switch to position 0.
9. Turn the power switch back on at the VPS.
0
1
1234