2.5 System Parameters
114 Programming Guide
Feature Guide References
2.1.2 Auto Configuration (APT/DPT Integration Only)
Operator Transfer Sequence
Specifies the sequence for transferring calls to an operator's extension.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
1–9, 0, , #: Dial Code
Extension Transfer Sequence
Specifies the sequence for transferring calls to any extension except an operator's extension.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
1–9, 0, , #: Dial Code
Alternate Extension Transfer Sequence
Specifies the sequence for transferring calls to extensions in the Alternate Extension Group.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
To Next Page
Loading...
