Panasonic KX-TVM50 - Page 134

2.5 System Parameters
134 Programming Guide
EFA Transfer Reconnect Sequence on Busy
Specifies the sequence the VPS uses to reconnect the line when the party transferred with EFA
(External Feature Access) is busy.
Note
• The default value is only activated when the VPS is connected to default PBX (KX-TDA
series). For other PBX types, the default value differs depending on the EFA Transfer
Sequence specified in the PBX. For example, when the PBX type is changed to a KX-
TD1232/KX-TD500/KX-TA624 series PBX, the default value becomes "F6".
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
N: Telephone Number Dialling
1–9, 0, , #: Dial Codes
EFA Transfer Reconnect Sequence on No Answer
Specifies the sequence the VPS uses to reconnect the line when the party transferred with EFA
(External Feature Access) does not answer.
Note
• The default value is only activated when the VPS is connected to default PBX (KX-TDA
series). For other PBX types, the default value differs depending on the EFA Transfer
Sequence specified in the PBX. For example, when the PBX type is changed to a KX-
TD1232/KX-TD500/KX-TA624 PBX, the default value becomes "F6".
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
N: Telephone Number Dialling
1–9, 0, , #: Dial Codes
Call Transfer to Outside Answer Mode
Specifies the answering method the VPS uses to detect whether the destination party has answered
the transferred CO call.