2.5 System Parameters
136 Programming Guide
Value Range
Disable, Enable
Outside Line Access Sequence for Caller ID Callback
Specifies the sequence of Trunk Access numbers for Caller ID Callback. This parameter is available
when the VPS executes Caller ID Callback without using EFA.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
1–9, 0, , #: Dial Codes
Use Caller-ID Modify Table No.
Specifies which Caller ID Modify Table is used when the VPS converts the Caller ID Number sent
from the PBX to the VPS.
Value Range
1–4
Caller-ID Modify Table No.1–No.4
A maximum of 4 Caller ID Modify tables can be assigned.
Local Area/International Call Code
Specifies the parameters for each Local Area/International Call Code.
Follow the steps below to edit Local Area/International Call Code:
1. Click Click to edit….
2. Select a desired Local Area/International Call Code No. (1–10).
3. Edit each parameter in the Local Area/International Call Code dialogue box.
4. Click OK.
Local Area Code/International Code
Specifies the local area/international codes that are used when the VPS converts the Caller ID
Number sent from the PBX to the VPS.
Value Range
Max. 6 digits consisting of 0–9
To Next Page
Loading...
