33
2. Getting Started/Basic Operations
Attaching/Removing the Lens
By changing the lens, you will increase your picture taking-options and further your
enjoyment of the camera.
• Check that the camera is turned off.
• When attaching or detaching the interchangeable lens (H-FS12032/H-FS35100), retract the
lens barrel.
• Change lenses where there is not a lot of dirt or dust. Refer to P315 when dirt or dust gets on
the lens.
• Attach the lens cap.
While pressing on the lens release button A,
rotate the lens toward the arrow until it stops
and then remove.
• Hold the part around the base of the lens to rotate it.
• When the lens is removed from the camera body, make sure to attach the body cap to the
camera body and attach the lens rear cap to the lens.
• If the lens rear cap is fitted to the lens, remove it.
• If the body cap is fitted to the camera, remove it.
Align the lens fitting marks B and then rotate the lens in the direction of the arrow
until it clicks.
• Do not press the lens release button C when you attach a lens.
• Do not try to attach the lens when holding it at an angle to the camera body as the lens mount
may get scratched.
Detaching the lens
Attaching the lens
To Next Page
Loading...
Need help?
General
