- 85 -
Printing
Getting Ready:
• Charge the battery sufficiently.
• When copying pictures from the
built-in memory, remove any memory
cards.
• Adjust the print quality or other
settings on your printer, as needed.
• Turn on the camera and printer.
Connect camera to printer
• Please make sure you use the supplied USB connection cable. Use of cables
other than the supplied USB connection cable may cause malfunction.
Use cursor button on the camera to select [PictBridge (PTP)],
and press [MENU/SET]
Use cursor button to select a picture to print and press
[MENU/SET]
Use cursor button to select [Print start] and press [MENU/SET]
(Print settings (→87))
■
To cancel print Press [MENU/SET]
●
Do not use any other USB connection cables except the supplied one.
●
Disconnect USB connection cable after printing.
●
Turn off power before inserting or removing memory cards.
●
When the battery begins to run out during communication, a warning beep sounds.
Cancel printing and disconnect USB connection cable. Use a sufficiently charged
battery.
Check socket direction and insert straight in.
(Damage to socket shape can lead to faulty
operation.)
• Do not disconnect the USB connection cable when
the cable disconnection icon
is displayed (may not
be displayed with some printers).
USB connection cable
(always use cable supplied)
You can connect directly to a PictBridge-compatible printer for printing.
• Some computers can read directly from the camera’s memory card.
For details, see the manual for your computer.
To Next Page
Loading...
Need help?
General
