- 123 -
Advanced (Playback)
You can add text (comments) to pictures. After text has been registered, it can be included
in prints using [TEXT STAMP] (P125). (Only alphabetic characters and symbols can be
entered.)
Names set in [BABY1]/[BABY2] and [PET] in scene mode and [LOCATION] in travel date
are also recorded as the titles.
You can use the stylus pen (supplied) if it is hard to operate with your fingers.
Enter characters.
• Touch [ ] to switch text between [A] (capitals), [a]
(small case), and [&/1] (special characters/numbers).
• The cursor at the entry position can be moved to the
left with touching [ ], and to the right with touching
[].
• To enter a blank, touch []], or to delete an entered
character, touch [DELETE].
• To stop editing at any time during text entry, touch [CANCEL].
• A maximum of 30 characters can be entered. (Maximum of 9 characters when setting
names in [FACE RECOG.])
Touch [EXIT].
∫ Delete the title
1 In step 5, delete all the texts.
2 Touch [EXIT].
[TITLE EDIT]
Touch [ ].
Touch [TITLE EDIT].
Touch the image from the thumbnail at the
bottom of the screen, and touch the main
image
.
• Repeat the step to set more than 2 images.
• Up to 50 pictures can be selected at once.
• Selection will be cancelled by touching the same
picture again.
• Selection of all pictures will be cancelled by touching
[CANCEL].
Touch [OK].
To Next Page
Loading...
