Advanced (Recording pictures)
- 98 -
For details on [REC] mode menu settings, refer to P23.
This allows the sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
Applicable modes:
³±´²
[AUTO]/[80]/[100]/[200]/[400]/[800]/[1600]
Note
•
When setting to [AUTO], ISO sensitivity is automatically adjusted to the maximum of the value
set in [ISO LIMIT SET] (excluding [AUTO]).
• The setting is not available when [INTELLIGENT ISO] is being used. ([ ] is displayed.)
• If picture noise becomes a problem, we recommend that you take pictures after lowering the
ISO sensitivity level, increasing the setting for [NOISE REDUCTION] under [PICT.ADJ.], or
lowering the setting for each of the items other than [NOISE REDUCTION]. (P107)
For details on [REC] mode menu settings, refer to P23.
Most appropriate sensitivity within the range set will be set depending on the brightness of
the subject.
Applicable modes:
³±´²
[AUTO]/[200]/[400]/[800]/[1600]
•
The upper limit of the ISO sensitivity can be set.
• The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
Note
•
This will work when the [SENSITIVITY] is set to [AUTO] or when the Intelligent ISO is set to
[ON].
• When [SENSITIVITY] is set to [AUTO], and [ISO LIMIT SET] is set to [AUTO], the ISO
sensitivity is automatically set to a maximum of [ISO400] ([ISO1000] when the flash is used)
according to the brightness.
[SENSITIVITY]
ISO sensitivity
80 1600
Recording location (recommended) When it is light (outdoors) When it is dark
Shutter speed Slow Fast
Noise Less Increased
[ISO LIMIT SET]
To Next Page
Loading...
