Advanced (Recording pictures)
- 82 -
This takes pictures of a baby with a healthy complexion. When you use the flash, the light
from it is weaker than usual.
It is possible to set different birthdays and names for [BABY1] and [BABY2]. You can
select to have these appear at the time of playback, or have them stamped on the
recorded image using [TEXT STAMP] (P146).
∫ Birthday/Name setting
1 Touch [SET] of [AGE] or [NAME].
2 Enter the birthday or name.
•
When the birthday or name is set, [AGE] or [NAME] is automatically set to [ON].
• If [ON] is selected when the birthday or name has not been registered, the setting screen
appears automatically.
3 Touch [EXIT] to finish.
∫ To cancel [AGE] and [NAME]
Select the [OFF] setting in step
1.
Note
•
During motion picture recording, settings for [PORTRAIT] are used.
• The age and name can be printed out using the “PHOTOfunSTUDIO 5.2 HD Edition” bundled
software on the CD-ROM (supplied).
• If [AGE] or [NAME] is set to [OFF] even when the birthday or name has been set, the age or
name will not be displayed. Before taking pictures, set [AGE] or [NAME] to [ON].
• The focus range is 3 cm (0.10 feet) (Wide)/1 m (3.28 feet) (Tele) to ¶.
• When the camera is set to [STABILIZER] and there is very little jitter, or if [STABILIZER] is set
to [OFF], shutter speed may slow down up to 1 second.
• Intelligent ISO is activated, and maximum ISO sensitivity level becomes [ISO1600].
• If the camera is turned on with [BABY1]/[BABY2] set, the age and name are displayed on the
screen for about 5 seconds, along with the current date and time.
• If the age is not properly displayed, check the clock and birthday settings.
• The birthday setting and name setting can be reset with [RESET].
• The initial setting for [AF MODE] is [š].
[BABY1]/[BABY2]
Birthday: Touch [3]/[4] for each item to set
year/month/day, and touch [SET].
Name: For details on how to enter characters,
refer to “Entering Text” on P128.
To Next Page
Loading...
