- 163 -
Playback/Editing
You can add text (comments) to pictures. After text has been registered, it can be stamped in
prints using [Text Stamp] (P164).
1
Select [Title Edit] on the [Playback] menu. (P52)
2
Press 3/4 to select [Single] or [Multi] and then press [MENU/SET].
4
Enter the text. (P132)
• Exit the menu after it is set.
Note
•
To delete the title, erase all the text in the text input screen.
• You can print out texts (comments) using the “PHOTOfunSTUDIO” bundled software on the
CD-ROM (supplied).
• You cannot use [Title Edit] for the following pictures.
– Motion pictures
– 3D pictures
– Pictures recorded with other equipment
[Title Edit]
3
Select the picture, and then press
[MENU/SET] to set.
• [’] is displayed for pictures with titles
already registered.
[Multi] setting
Press [DISP.] to set (repeat), and then
press [MENU/SET] to set.
•
The setting is canceled when [DISP.] is
pressed again.
[Single] [Multi]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.
(DMC-FZ200)
•
You can set up to 100 pictures at one time with [Multi].
(DMC-FZ60)
•
You can set up to 50 pictures at one time with [Multi].
(DMC-FZ200)
–
Pictures taken with [ ], [ ] or [ ]
To Next Page
Loading...
