- 147 -
Recording
• It will display dial operation guide to the screen that is possible to
perform Exposure Compensation, Programme Shift, aperture setting,
or shutter speed setting when set to [ON].
A Dial operation guide
• Imaging device and image processing is optimised when the camera is purchased. Use this
function when bright spots not in subject get recorded, and it is bothering you.
• Turn the camera off and on after the pixels are corrected.
• Dust reduction function will operate automatically when the camera is turned on, but you can
use this function when you see dust. (P197)
• When using a Leica lens mount adaptor (DMW-MA2M, DMW-MA3R; optional), set it to [ON].
[DIAL GUIDE]
Select whether or not to display the operation switch guide when the
[REC] Mode is set to ³/±/´/² etc.
[OFF]/[ON]
[MENU RESUME]
The last operated menu position is saved even if the camera is
turned off.
[OFF]/[ON]
[PIXEL REFRESH]
It will perform optimization of imaging device and image
processing.
[SENSOR CLEANING]
Dust reduction to blow off the debris and dust that have affixed to
the front of the imaging device is performed.
[SHOOT W/O LENS]
It is possible to setup so the shutter will not operate when there is
no lens on the unit.
[OFF]: You cannot press the shutter button when a lens is not
attached to the camera body or is not attached
correctly.
[ON]: Shutter will operate regardless of the lens on the unit.
To Next Page
Loading...
Need help?
General
