- 165 -
Connecting to other equipment
Connecting to other equipment
Enjoying 3D pictures
Attaching the 3D interchangeable lens (H-FT012; optional) to the camera allows you to
take 3D pictures for extra impact.
To view 3D pictures, a television that supports 3D is required.
Attach the 3D interchangeable lens to the camera.
Bring the subject into the frame and record by pressing the shutter
button fully.
• Focusing is not required when recording 3D pictures.
• Still pictures recorded with the 3D interchangeable lens attached are saved in MPO
format (3D).
Note
•
You cannot record 3D pictures in vertical orientation.
• It is recommended to use a tripod or a flash to record steady pictures.
• When a distance to the subject is 0.6 m (1.97 feet) to approximately 1 m (3.28 feet), horizontal
disparity becomes too great, and you may not see the 3D effect at the edges of the image.
• Up to approx. 650 3D pictures can be recorded on a 2 GB card. (When the aspect ratio is set to
[X], and the quality is set to [ ].)
• Read the operating instructions of the 3D interchangeable lens for details.
Taking 3D pictures
3D picture
The image is an illustration.
To ensure that the 3D pictures can be safely viewed, pay attention to the
following points when recording.
•
Where possible, record with the unit in a horizontal state.
• Do not get too close to the subject [when the 3D interchangeable lens (H-FT012; optional) is
used, record from a distance of at least 0.6 m (1.97 feet)].
• Be careful not to shake the camera while in a vehicle or walking.
To Next Page
Loading...
Need help?
General
