- 71 -
Recording
[REC] Mode:
Taking Pictures using the Built-in Flash
A To open the flash
B To close the flash
Press the flash until it clicks.
•
Be sure to close the flash when not in use.
• The flash setting is fixed to [Œ] while the flash is
closed.
Note
•
Be careful when opening the flash as the flash will jump out.
• Be careful not to catch a finger when closing a flash bulb.
Applicable modes:
Set the built-in flash to match the recording.
•
Open the flash.
1 Select [FLASH] in the [REC] Mode menu. (P56)
2 Press 3/4 to select a mode and press [MENU/SET].
•
For information about flash settings that can be selected, refer to “Available flash
settings by Recording Mode
”. (P73)
Switching to the appropriate flash setting
To Next Page
Loading...
Need help?
General
