Basic
- 62 -
• Press the shutter button halfway or turn the camera off and on to cancel [SLEEP MODE].
• [SLEEP MODE] is set to [5MIN.] in the Intelligent Auto Mode.
• [SLEEP MODE] is fixed to [2MIN.] when [AUTO LCD OFF] is set to [15SEC.] or [30SEC.].
• Press any button to turn on the LCD monitor again.
• [SLEEP MODE] does not work in the following cases.
– When using the AC adaptor
– When connecting to a PC or a printer
– When recording or playing back motion pictures
– During a slide show
• If it is set to [HOLD] when the camera is set to [ ] (P34) or [ ] (P83), switching of the
playback screen display (P39) or enlargement by rotating the rear dial is possible during Auto
Review.
• Regardless of the Auto Review setting, pictures will automatically be reviewed when taking
burst pictures with [H] set (P79), and recording with Auto Bracket (P81). (Will not hold) Also,
you cannot set the Auto Review function.
• If [HIGHLIGHT] (P142) is set to [ON], white saturated areas appear blinking in black and white
when the Auto Review function is activated.
• [AUTO REVIEW] is disabled when Burst Mode is set to [M] or [L].
• When [AUTO REGISTRATION] in [FACE RECOG.] (P119) is set to [ON], [AUTO REVIEW] can
only be set to [3SEC.] or [5SEC.].
q [ECONOMY]
You can conserve the battery life by setting these menus.
Also, it will turn off the LCD monitor automatically when not in use
to prevent discharge of the battery.
p [SLEEP MODE]:
The camera is automatically turned off if the camera has not been
used for the time selected on the setting.
[OFF]/[1MIN.]/[2MIN.]/[5MIN.]/[10MIN.]
[AUTO LCD OFF]:
The LCD monitor is automatically turned off if the camera has not
been used for the time selected on the setting.
[OFF]/[15SEC.]/[30SEC.]
o [AUTO REVIEW]
Set the length of time that the picture is displayed after taking it.
[OFF]/[1SEC.]/[3SEC.]/[5SEC.]
[HOLD]:
The pictures are displayed until shutter button is pressed halfway.
To Next Page
Loading...
Need help?
General
