Recording
- 82 -
∫ Changing the settings for [ / SETTINGS], [STEP] and [SEQUENCE] in Auto
Bracket
1 Select [AUTO BRACKET] in the [REC] Mode menu. (P56)
2 Press 3/4 to select [ / SETTINGS], [STEP] or
[SEQUENCE] and then press [MENU/SET].
3 Press 3/4 to select the setting and then press [MENU/SET].
•
You can take one picture at a time when set to [ ].
• You can continuously take pictures up to set numbers when set to [ ].
4 Press [ ] twice to close the menu.
Note
•
When taking pictures using Auto Bracket after setting the Exposure Compensation range, the
pictures taken are based on the selected Exposure Compensation range.
• The exposure may not be compensated with Auto Bracket depending on the brightness of the
subject.
• When taking pictures continuously using Auto Bracket with [I.RESOLUTION] set to
[EXTENDED], it may take time to record all the set number of pictures.
• The Auto Review function is activated regardless of the Auto Review setting. (Will not hold) You
cannot set the Auto Review function in the [SETUP] menu.
• When the flash is activated, you can take only 1 picture.
• Auto Bracket is disabled when White Balance Bracket is set.
• The Auto Bracket will be disabled during recording of the motion pictures.
Item Settings Item Settings
[ / SETTINGS]
[ ] (single)
[SEQUENCE]
[0/`/_]
[] (burst) [`/0/_]
[STEP]
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
To Next Page
Loading...
Need help?
General
