VQT3A48
22
Preparation
Attach the lens cap.
Press the lens release button D while
turning the lens as far as possible in the
direction of the arrow to detach it.
• Always attach the body cap to the camera body so
that dirt or dust does not get inside.
• Attach the lens rear cap so that the lens contact
point does not get scratched.
Note
•
It is recommended to attach the lens cap or attach the MC Protector (optional) to protect the
lens surface when carrying. (P172)
In bright sunlight or backlight, the lens hood will minimise lens flare and ghosting. The lens
hood cuts off excess lighting and improves the picture quality.
To attach the lens hood (flower shape) that came with the lens supplied in
DMC-GH2H/DMC-GH2K
Insert the lens hood into the lens
with the short sides at the top and
bottom, and turn in the direction
of the arrow until it stops.
A Fitting to the mark.
Note
•
When temporarily detaching and carrying the lens hood supplied
with the DMC-GH2H/DMC-GH2K, attach the lens hood to the lens
in the reverse direction.
Detaching a lens from the camera body
Attaching the Lens Hood
DMC-GH2H&GH2K&GH2EB-VQT3A48_eng.book 22 ページ ２０１０年１０月１４日 木曜日 午後３時５０分
To Next Page
Loading...
