82
Wi-Fi/NFC
VQT5H68 (ENG)
You can send location information acquired with a smartphone to the camera. After
sending the information, you can also write it on images stored in the camera.
1 Start recording location
information
2 Start recording images
3 Finish recording the location
information
4 Sending and writing location
information
•
Location information different from that
at the time of recording may be written.
Keep the following points in mind:
– Set the camera’s [Home] setting in [World Time] to your region.
– Once you start recording location information with your smartphone, do not change the
camera’s [Home] setting in [World Time].
•
Location information cannot be written on images that were recorded when the clock was not set.
∫ Start recording location information
Operate the smartphone.
∫ Finish recording the location information
Operate the smartphone.
∫ Sending and writing location information
1 Connect to a smartphone. (P76)
2 Operate the smartphone.
•
Cautions for Use:
Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject
when you use this function. Use at your own risk.
• (When using “Image App” for iOS)
If you press the Home or On/Off button of a smartphone while [Rec. loc. Info] is working,
location information recording is stopped.
Adding location information to images stored in the camera from a
smartphone/tablet
1 Select [ ].
2 Select [Geotagging].
3 Select [ ].
1 Select [ ].
2 Select [Geotagging].
3 Select [ ].
1 Select [ ].
2 Select [Geotagging].
3 Select [ ].
•
Follow the on-screen messages to operate the smartphone.
• Location information is not written onto the images recorded when [Rec Format] is set
to [AVCHD].
• When the card in the camera lacks sufficient free space, writing location information
may not be possible.
GPS
DMC-GH4_PPC-VQT5H68_eng.book 82 ページ ２０１４年３月１２日 水曜日 午後１０時３５分
To Next Page
Loading...
Need help?
General
