57
Recording
(ENG) VQT5H68
Taking pictures by using the flash
Taking a picture using the flash becomes possible by opening
the built-in flash.
A To open the flash
Turn the camera on, and press the flash open button.
B To close the flash
Push the top part of the built-in flash from directly above.
•
Forcibly closing the flash can damage the camera.
• Make sure to close the built-in flash when it is not in use.
• The flash setting is fixed to [Œ] while the flash is closed.
• Be careful not to catch a finger when closing a flash bulb.
• In the following cases, the flash is fixed to [Œ] (forced flash off).
– When recording motion pictures
– When [Electronic Shutter] is set to [ON]
– When [HDR] is set to [ON]
– When [Silent Mode] is set to [ON]
Set the built-in flash to match the recording.
1 Select the menu. (P28)
2 Press 3/4 to select the item and then press [MENU/SET].
Applicable modes:
Changing Flash Mode
Applicable modes:
> [Rec] > [Flash] > [Flash Mode]
‰ ([Forced Flash On])
([Forced On/Red-Eye])
The flash is activated every time regardless of the recording
conditions.
• Use this when your subject is back-lit or under
fluorescent light.
([Slow Sync.])
([Slow Sync./Red-Eye])
When taking pictures against a dark background landscape,
this feature will slow the shutter speed when the flash is
activated. Dark background landscape will appear brighter.
• Use this when you take pictures of people in front of a
dark background.
• Using a slower speed can cause motion blur. Using a
tripod can enhance your photos.
MENU
DMC-GH4_PPC-VQT5H68_eng.book 57 ページ ２０１４年３月１２日 水曜日 午後１０時３５分
To Next Page
Loading...
Need help?
General
