69
Wi-Fi/NFC
(ENG) VQT5B20
Search for available wireless access points.
• Confirm encryption key of the selected wireless access point if the network authentication is
encrypted.
• When connecting by [Manual Input], confirm SSID, encryption type, encryption key of the
wireless access point you are using.
1 Select the wireless access point you are connecting
to.
•
Pressing [DISP.] will search for a wireless access point
again.
• If no wireless access point is found, refer to “When
connecting with [Manual Input]
” on P69.
2 (If network authentication is encrypted)
Enter the encryption key.
∫ When connecting with [Manual Input]
1 On the screen displayed in step 1 of “If you are not sure about the WPS
compatibility (connecting by [Manual Connection])”, select [Manual Input].
2 Enter the SSID of the wireless access point you are connecting to, then select
[Set].
3 Select the network authentication type.
•
For information on network authentication, see the manual of the wireless access point.
4 Select the encryption type.
•
The type of settings that can be changed may vary depending on the details of network
authentication settings.
5 (When an option other than [No Encryption] is selected)
Enter the encryption key.
•
Check the wireless access points instruction manual and settings when saving a wireless
access point.
• Transmission speed may decrease, or may not be usable depending on the environment it is
used in.
If you are not sure about the WPS compatibility (connecting by [Manual
Connection])
Network authentication type Encryption types that can be set
[WPA2-PSK]/[WPA-PSK] [TKIP]/[AES]
[Common Key] [WEP]
[Open] [No Encryption]/[WEP]
DMC-GX7K&GX7GN-VQT5B20_eng.book 69 ページ ２０１３年７月２２日 月曜日 午後２時５０分
To Next Page
Loading...
