194
SQW0724
Using Menu Functions
Menu list
→ [Custom]
[Highlight]
You can set overexposed areas (areas that are too bright and where there are no shades
of grey) to flash on the screen when the [Auto Review] function is activated or during
playback. This does not affect recorded pictures.
●
To reduce overexposed areas, record a picture by setting negative
exposure compensation (→103) using the histogram display (→193) and
so on as a reference.
●
This feature is disabled during 4K photo playback, playback of pictures
recorded in Post Focus, Multi Playback, Calendar Playback, or Playback
Zoom.
[Zebra Pattern]
You can check the area in a picture, which could result in overexposure, by displaying
such an area using a zebra pattern.
[ZEBRA1]: [ZEBRA2]:
Select [SET] to set the brightness to be displayed for each zebra pattern.
• The range of brightness you can select from is [50%] to [105%]. The [OFF] setting is
available for [Zebra 2]. When [100%] or [105%] is selected, only the overexposed areas
are displayed with the zebra pattern. When a smaller numeric value is set, the range of
brightness to be displayed by each zebra pattern will increase.
●
To reduce overexposed areas, record a picture by setting negative exposure compensation
(→103) using the histogram display (→193) and so on as a reference.
●
The displayed zebra pattern is not recorded.
●
If you set [Zebra Pattern] to [Fn Button Set] (→46) in the [Custom] menu, every time you press
the assigned function button the setting will switch in the following order: [Zebra 1] → [Zebra 2]
→ [Zebra OFF]. When [Zebra 2] is set to [OFF], you can switch the setting quickly in the following
order: [Zebra 1] → [Zebra OFF].
To Next Page
Loading...
Need help?
General
