Preparation
15
VQT0V40
Inserting/Removing
the Card
• Check that the camera is turned off and
that the lens is retracted.
• Prepare an SD Memory Card (optional) or
a MultiMediaCard (optional).
• You can record or play back pictures
on the built-in memory when you are
not using a card. (P16)
1 Slide the release lever in the
direction of the arrow and open
the card/battery door.
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.
• The card may be damaged if it is not
fully inserted.
3 1 Close the card/battery door.
2 Slide the release lever in the
direction of the arrow.
• If the card/battery door cannot be
completely closed, remove the card and
insert it again.
• The card and the data may be damaged
if it is inserted or removed while the
camera is on.
• We recommend using Panasonic’s SD
Memory Card.
OPEN LOCK
OPEN LOCK
VQT0V40ENG.book 15 ページ ２００６年２月２７日 月曜日 午後１時１９分
To Next Page
Loading...
Need help?
General
