Connecting to other equipment
92
VQT0V40
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-]
(for Windows
®
) in the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use Windows
98/98SE, install the
USB driver and then connect it to the
computer.
For information about installing [LUMIX
Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] etc., refer to
the separate operating instructions for PC
connection.
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC5; optional)
• Use a battery with sufficient battery power
or the AC adaptor (DMW-AC5; optional).
• Turn the camera off before inserting or
removing the cable for the AC adaptor
(DMW-AC5; optional).
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [1] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
D: This message appears during data
transfer.
3 Press 3 to select [PC] and then
press [MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PC] in advance, it is not
necessary to set this every time you
connect to a PC. (P23)
SCN1
SCN
2
DIGITAL
AV OUT
DC IN
ACCESS
USB MODE
SELECT SET
MENU
MENU
SET
PictBridge(PTP)
PC
PLEASE SELECT
THE USB MODE
VQT0V40ENG.book 92 ページ ２００６年２月２７日 月曜日 午後１時１９分
To Next Page
Loading...
Need help?
General
