Connecting to other equipment
93
VQT0V40
• If you set [USB MODE] to [PictBridge
(PTP)] and then connect the camera to
the PC, messages may appear on the
screen of the PC.
Select [Cancel] to close the messages
and disconnect the camera from the
PC. Set [USB MODE] to [PC] again.
[Windows]
The drive appears in the [My Computer]
folder.
• If you are connecting the camera to a PC
for the first time, the required driver is
installed automatically so that the camera
can be recognized by Windows Plug and
Play. The drive then appears on the
[My Computer] folder.
[Macintosh]
The drive is displayed on the screen.
• The drive is displayed as [LUMIX] when
you connect the camera with no card
inserted.
• The drive is displayed as [NO_NAME] or
[Untitled] when you connect the camera
with a card inserted.
∫ Folder Composition
Folders are displayed as shown in the
following illustration.
1 Folder number
2 File number
3 JPG: pictures
MOV: motion pictures
The items in each folder are as follows.
• The data for up to 999 pictures recorded
by the camera can be included in 1 folder.
If the number of pictures exceeds 999,
another folder is created.
• To reset the file number or the folder
number, select [NO.RESET] in the
[SETUP] menu. (P22)
DCIM Folders from [100_PANA] to
[999_PANA]
100_PANA to
999_PANA
Pictures/motion pictures
MISC Files on which the DPOF
print settings are recorded
PRIVATE1 Pictures recorded in flip
animation function
100_PANA
101_PANA
999_PANA
DCIM
MISC
P1000001.JPG
P1000002.JPG
P1000999.JPG
100_PANA
1
23
PRIVATE1
≥Built-in memory
≥SD Memory Card
≥MultiMediaCard
VQT0V40ENG.book 93 ページ ２００６年２月２７日 月曜日 午後１時１９分
To Next Page
Loading...
