24 VQT2R48 VQT2R48 25
For details about the setting procedure in the [SETUP] menu (→20)
Using the [SETUP] menu (Continued)
[REC AREA]
Enables verification of
the recordable area for
a motion picture before
recording.
[OFF]/[ON]
• Recordable area displayed for motion
pictures should be interpreted as a
Guideline.
• When using Extra Optical Zoom, the
recordable area may not always be
displayed for certain zoom ratios.
• This setting cannot be used with Intelligent
Auto Mode.
This section is not
recorded.
[ECONOMY]
Turn off the power or
make the LCD monitor
go dark while not using
the camera to minimize
battery consumption.
[SLEEP MODE]
[OFF]/[2 MIN.]/[5 MIN.]/[10 MIN.]:
Automatically shut off power while not in use.
• To restore → Press the shutter button halfway, or turn on
the power again.
• Cannot be used in the following cases:
When using AC adaptor (optional) and DC coupler
(optional), when connected to computer/printer, during
motion picture recording/playback, during Slide Shows,
during automatic demo playback
• Settings fixed to [5 MIN.] in [INTELLIGENT AUTO] Mode
or [CLIPBOARD] Mode, or [10 MIN.] while Slide Show is
paused.
[LCD POWER SAVE]
[OFF]/[ON]:
The LCD monitor goes dark to minimize power
consumption.
• Reduces the picture quality of the LCD monitor display
during recording to minimize battery consumption
(except for the Digital Zoom area). Note, however, that
there is no effect on the recorded picture.
• When [LCD MODE] is set, the brightness of the LCD
monitor follows the setting in [LCD MODE], but the
picture quality of the LCD monitor stays at a low level.
Item Settings, notes
For details about the setting procedure in the [SETUP] menu (→20)
[AUTO REVIEW]
Automatically display
still pictures immediately
after taking them.
[OFF]: No auto review
[1 SEC.]/[2 SEC.]: Automatically display for 1 or 2
seconds.
[HOLD]: Auto review screen remains until a button (other
than the [DISPLAY] button) is pressed
• Fixed to [2 SEC.] in [INTELLIGENT AUTO] Mode.
• In [SELF PORTRAIT], [PANORAMA ASSIST], [HI-
SPEED BURST], [FLASH BURST], and [PHOTO
FRAME] Scene Modes, [AUTO BRACKET], [MULTI
ASPECT], [BURST] Mode, or still pictures with audio,
Auto Review performed regardless of setting.
• Motion pictures cannot be automatically reviewed.
[ZOOM RESUME]
Remember the zoom
position when turning the
power off.
[OFF]/[ON]
• Cannot be set when using [SELF PORTRAIT] Scene
Mode.
[NO.RESET]
Reset picture file
numbers.
[YES]/[NO]
• The folder number is updated and the file number starts
from 0001.
• A folder number between 100 and 999 can be assigned.
Numbers cannot be reset once folder number reaches
999. In this case, save all necessary pictures to your
computer, and format the built-in memory/card (→28).
• To reset folder number to 100:
First, format the built-in memory or card, and reset the
file numbers using [NO.RESET]. Then, select [YES] on
the folder number reset screen.
• File numbers and folder numbers. (→142)
Item Settings, notes
[REC AREA] is not available in the DMC-TZ8/DMC-ZS5.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
