Panasonic MC-E464

11
2
HOW TO REPLACE - DRIVE BELT TYPE UB-1L /
BEATER BAR ASSEMBLY
1. Remove the 4 screws from the base plate and lift
it off. (Fig. 1)
2. Release the belt from the motor shaft and lift the
beater bar assembly to remove the belt. (Fig. 2)
3. To reassemble the beater bar assembly, simply
return the belt to the motor shaft and beater bar
pulley.
Re-insert the beater bar mounts to their holding
points, and turn the beater bar to ensure that the
belt has been seated correctly.(Fig. 3)
IMPORTANT: On model MC-E464, when
replacing the belt, make sure it is placed between
the screw and the inside cover rib, as indicated.
4. Replace the base plate and re-fasten the screws
securely.
HOW TO REPLACE - BEATER BAR / SIDE
BRUSHES / BEARING SUPPORT A-B
1. First remove the base plate, drive belt and lift out
the rotary brush assembly (as illustrated above).
2. Remove the 2 screws at both ends of the rotary
brush assembly and separate the different parts
as shown in the exploded view.
3. Replace any damaged part and reassemble in
reverse order.
➀. Beater bar
➁. Side brush
➂. Bering support A
➃. Bearing support B
REMOVE PLUG BEFORE
REMOVING THIS COVER
4
1
3
2
Fig. 2
Fig. 3
Fig. 1
4
3
2
1
SERVICING AND REPAIRS
Before replacing any part DISCONNECT THE CLEANER FROM THE MAINS SUPPLY.
We always recommend you use genuine Panasonic replacement parts only.
If you have any query, contact your local Panasonic dealer / service agent.
To replace any of the following parts, place the vacuum cleaner in the horizontal
position by using the pedal. Then turn it over exposing the underside.
MC-E464 only
Screw
Cover
rib