HOW TO ASSEMBLE / OPERATE YOUR CLEANER
5
1) Turn the upper hook to
release the power cord for
instant use.
To start or stop the vacuum cleaner push
the switch button to " I " to turn ON and to "
O " to turn OFF.
2) Fix the power cord by
the cord clip to help secure
the cord during use.
B) POWER CORD RELEASE / STORAGE
1) Insert the base of the handle
into the top of the body of the
machine as shown. Push in
handle and tighten the screw.
NOTE: To avoid any possible damage to the power cord,
never run over the cord or allow it to become caught in
the beater bar.
2) Set the hose around the hose
clip.
3) Turn the upper cord hook in
the upright position and wind the
power cord around the upper and
lower cord hooks.
IMPORTANT: Do not overtighten
the screw.
Hose clip
Upper cord hook
Lower
cord hook/
Carrying
handle
NOTE: Always place the hose in
the clockwise direction.
A) HANDLE ASSEMBLY
C) ON / OFF SWITCH
To Next Page
Loading...
