9
IMPORTANT NOTE: Before servicing any part, always
DISCONNECT THE CLEANER FROM THE ELECTRICITY MAINS
Central Filter (Fig. 1) Part no. AMC8F0391100
The central filter (foam filter) is installed in the dust
bag compartment to protect the motor from dirt.
When it becomes dirty, simply rinse it out in warm
water and dry it thoroughly before replacing.
To remove the central filter, hold the filter at the
top (as illustrated) and pull it out.
Important: Ensure that the filter is completely
dry before re-installing it into the cleaner.
Clean Air Filter (Fig. 2) Part no. AMC8F28G1000
The clean air filter (electrostatic), is installed in the
dust cover. This filter retains any small dust
particles which may be present in the expelled air.
It is advisable to change the clean air filter when it
becomes dirty. As a guide, once or twice a year is
usually sufficient, depending on use.
To change the clean air filter, first remove the dust
cover and then slide out the filter support and
simply unhook the filter from the retaining ribs.
1) Remove dust cover simply
pulling it forwards.
2) Grip the cardboard of the dust
bag and pull out.
3) Install the dust bag by pressing
the cardboard as shown.
Before replacing the dust cover,
make sure all edges of the dust
bag are completely inside the
bag compartment.
IMPORTANT: Never use the cleaner without the correct filters properly installed. Failure to do so
may result in motor damage.
We recommend the use of genuine Panasonic bags Type U-20E only.
IMPORTANT: Dust bags should be changed regularly for the
maximum efficiency of the filters and prolonged motor efficiency.
HOW TO CHANGE THE DUST BAG
FILTER CARE
Fig. 2
Fig. 1
MAINTENANCE AND SERVICING
To Next Page
Loading...
