Panasonic MCO-170AICUVH Series - Manual CO2 Gas Supply Line Changeover

73
Manual CO
2
gas supply line changeover
It is possible to change CO
2
gas supply line manually anytime.
Example) Change CO
2
gas supply line A to B.
1. Press CO
2
gas supply line select key for a few
seconds.
2. CO
2
gas supply line A is changed to B.
Note: The behavoir for the following case is shown in Table 3.
After the CO
2
gas supply line is changed over by CO
2
gas automatic changer function, the empty CO
2
gas
is manually retuned to the CO
2
gas supply line before the Buzzer key is pressed.
Table 3 After changed into CO
2
gas cylinder B because CO
2
gas cylinder A is empty, if you
changed into A manually.
Situation
CO
2
gas CO
2
gas supply line indicator
Message
display field
Supply line Cylinder A Cylinder B A B
1
Changed into CO
2
gas supply line B
automatically
B Empty Remaining
Reverse
video
and blink
Light on
Err01:
CO
2
Gas Empty
(and buzzer)
2
Not press Buzzer key,
long-pressed CO
2
gas supply line select
key
A Empty Remaining Blink Light off
Err01:
CO
2
Gas Empty
(and buzzer)