Panasonic MCO-170M Series - Page 36

35
*1: MCO-170MUVH or when an optional electric lock MCO-170EL is installed.
*2: MCO-170MUVH/170MUV or when an optional UV system set MCO-170UVS is installed.
*3: When an optional STD gas auto calibration kit MCO-SG is installed.
Note: Service key is not available. (Qualified engineer only)
Note: On the Tools #1 screen, by mistakenly
pressing Temp./Gas Calibration key, Temp./Gas
Calibration screen is displayed.
When this screen is displayed, press Back key to
return to the Tools #1 screen, or press Top key to
return to the Top screen.
When these settings on this screen are changed,
inaccurate temperature, CO
2
density or O
2
density
may be displayed.
●Operation from other than Menu key
◆CO
2
gas supply line select key: (Operate) Manual changeover between CO
2
gas supply line A and B (Page 86)
◆N
2
/O
2
gas supply line select key: (Operate) Manual changeover
between N
2
/O
2
gas supply line A and B (Page 45)
◆Message select key:
(Operate) Changing some messages
◆H
2
O
2
key*
5
: (Operate) H
2
O
2
decontamination (Page 70～75)
◆Unlock key*
6
: (Operate) Unlock the outer door. (Page 80)
◆Buzzer key: (Operate) Silencing the buzzer (Alarm is not canceled except for some alarms; page 93)
*5: Under any of the following conditions only.
・When an H
2
O
2
generator MCO-HP is installed in the MCO-170MUVH.
・When all H
2
O
2
generator MCO-HP, H
2
O
2
decon board MCO-170HB and electric lock MCO-170EL in the
MCO-170MUV.
・When all UV system set MCO-170UVS, H
2
O
2
generator MCO-HP, H
2
O
2
decon board MCO-170HB and
electric lock MCO-170EL in the MCO-170M.
*6: For the MCO-170MUVH or an optional electric lock MCO-170EL is installed, when the auto lock
function is ON.