Panasonic MCO-170M Series - Page 9

8
PRECAUTIONS FOR SAFE OPERATION
Do not position this unit and the other unit so that it is difficult to operate the disconnection of
the power supply plug. Failure to disconnect the power supply plug may cause fire if there is
something wrong with the unit.
This unit must be plugged into a dedicated circuit protected by branch circuit breaker.
Use a dedicated power source as indicated on the rating label attached to the unit. A multiple-tap may
cause fire resulting from abnormal heating.
Never store corrosive substances such as acid or alkali in this unit if the container cannot be
sealed. These may cause corrosion of inner components or electric parts.
Check the setting when starting up of operation after power failure or turning off of power
switch. The stored items may be damaged due to the change of setting.
Be careful not to tip over the unit during movement to prevent damage or injury.
Prepare a safety check sheet (copy the last page) when you request any repair or maintenance for
the safety of service personnel.
Wear rubber gloves when handling the H
2
O
2
reagent. Direct contact with the H
2
O
2
reagent may
result in inflammation of the skin.
H
2
O
2
decontamination can be performed only for the chamber and chamber attachments with standard
specifications, and not for any other objects.
Perform H
2
O
2
decontamination with the chamber attachments arranged as specified by our
company. Arranging them in a different way may result in insufficient decontamination.
After H
2
O
2
decontamination has been completed, wear rubber gloves and use a non-woven cloth to
wipe off the residual H
2
O
2
fluid from the bottom of the chamber, any objects that were
decontaminated, and the bottoms of ducts.
Do not touch the hot surface. This may cause burns.
WARNING
CAUTION