Panasonic NA-140ZS1

46
Checking after Installation
Appliance parts checklist
Have you removed all 2 anchor
rods and fitted cover caps?
(P.42, 43)
Is the appliance plugged into an
AC 220-240 V household mains
socket? (see back cover)
Are they stable and securely
tightened? (P.43)
Is the water supply hose
properly connected? Is it free
from leaks? (P.45)
Is the appliance on a flat, stable
surface?
Does it run without vibrating?
(P.43)
Is the drain hose properly
connected? Does it drain
normally? (P.45)
Anchor rods Mains plug
Adjustable feet Water supply hose
Installation place Drain hose
Water supply hose
Mains plug
Adjustable feet (4)
Do not remove the fastener of the drain hose
in the upper left.
Drain hose
Anchor rods (2)
Is the appliance level? (P.43)
47
7
Installation
Service person only
Test run
C o tt on
4
0
4
00
2:32
6 3, 7745 9,10,118
1
Turn on the tap.
2
Close the door without any
laundry in the drum.
3
Switch on the appliance.
4
Select the “Quick 50”
programme.
5
Use the Mode function to
select M. (P.27)
6
Start operation.
7
Switch the appliance off
and on.
8
Press.
9
Select “3h” and
set.
10
Press for about 5
seconds.
“888” is displayed.
11
Press while “888” is
displayed to start test
run.
“0:03” is displayed.
Operation finishes after about
3 minutes.
Water leaks
Check the appliance and hose
joints for leaks. (P.44)
Abnormal noise
Make sure the appliance is
level. (P.43)
Error display
Unable to drain (P.40)
U11
U14
Unable to supply water
(P.40)
After resolving an error, open
and close the door and press
“Start/Pause” to resume the test.