EasyManua.ls Logo

Panasonic NA-FS80X1 - 7 Table of Errors; Services Check

Panasonic NA-FS80X1
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 22 -
7. TABLE OF ERRORS
7.1 Service Check
The number of pushing
the water level button
0
Check
Sequence
A
Check
Contents
• Timer display
• End information
• Power supply
auto-off
Display during operation : wash 3 min • rinse 1 time •
spin 40 sec and remaining time blinking.
• End buzzer sounds 3 times and [88] is blinking at
the same time. Turn off the power automatically after
operation. If other than [88] is indicated, please
check B.
1
B • Confirm washing
operation
• Confirm water
supply valve
operation
• Confirm bath
pump operation
Display during operation : wash 3 min blinks and
remaining time display counts down.
2
C • Confirm spin
operation
• Confirm the
cover switch
operation
• Perform washing sequence for 6 min even though
there is no water in a tank.
• By pushing [wash] button, 3 mode can be selected.
• To push [wash] button 1 time for passable confirma-
tion of the water supply valve.
• Push [wash] button 2 times to make a bath pump
passable.
• Push [wash] button 3 times to return for washing
sequence.
• In case of abnormal function in the controller, [H05]
will be indicated.
Display during operation : spin 40 sec blinks,
remaining time display counts down and [cover lock]
lamp turns on.
• Lock cover and operates spin sequence for 8 min.
• [22L] • [60L] of the water level turns on when contact
points of each cover switch turn off.
Lead switch ------------------ [ 22L]
Cover (SF) switch ---------- [60L]
For NA-FS70H1, it is 60L 59L
3
E • Setting to raise
2 ranks of
judgement water
level of the
quantity of cloth
detection
Display during operation : rinse 1 time • spin 40 sec
blinking, [L0] or [L1] blinking.
• To push [Washing] button, [L0] turns into [L1].
To push [Star/Hold] button for setting.
Water level is judged 2 rank higher in [L1].
Indication Operation
1. Turn off power supply.
2. Hold [washing] and [water level] botton at the same
time by one hand.
3. Turn on power supply.
4. Release the buttons as referred to above 2, 3 (Check A)
5. Push [water level] button within 3 seconds and select a
test sequence match it with a check sequence desired.
(Check B, C, E, G, H, P)
NA-FS80X1 / FS90X1
L
Water
volume
47
35
60
51
22
min
Wash
9
6
15
12
3
START
HOLD
Power
OFF
ON
onward

Other manuals for Panasonic NA-FS80X1

Related product manuals