- Eng-44 -
English
This unique feature built in sensor allows you to reheat a chilled meal with one push of the Dial. It is not
necessary to select the power level or cooking time. The built-in sensor measures the humidity of the food and
calculates the microwave power level together with a cooking time.
When clock or colon is displayed, press
the Dial to start.
To reset oven and return to clock or
colon, tap Stop/Cancel pad.
To reheat a chilled pre-cooked meal. All foods must be pre-cooked and at refrigerator temperature approx.+5 °C.
Reheat in microwave safe container as purchased. Pierce covering film with a sharp knife once in the center and
four times around the edge. If transferring food to dish, cover with pierced cling film. Place container on base
of oven. Press Dial to start the program. Stir at beeps. Stir again at end of program and allow a few minutes
standing time. Large pieces of meat/fish in a thin sauce may require longer cooking. This program is not suitable
for starchy food such as rice, noodles or potatoes. Meals in irregular bowl shaped containers may need longer
cooking.
Recommend weight range: 200 - 1000 g
Note:
1. Press the Dial in two minutes right after the door was closed, otherwise "One Push Reheating" will be
rejected and beeps will sound. Open the door and close it again will release the "One Push Reheating".
2. This feature is not suitable for foods that cannot be stirred eg. lasagne / macaroni cheese.
3. The oven automatically calculates the reheating time or the remaining reheating time.
4. The door should not be opened before the time appears in the display window.
5. To prevent any mistakes during "One Push Reheating" ensure that base of oven and the container are dry.
6. The room temperature should not be more than 35 °C and not less than 0 °C.
7. If the oven has previously been used and it is too hot to be used on "One Push Reheating", ‘HOT’ will appear
in the display window. After the ‘HOT’ disappears, the "One Push Reheating" may be used. If in a hurry, cook
food manually by selecting the correct cooking mode and cooking time yourself.
How it Works
Once the "One Push Reheating" has been selected and the Dial is pressed the food is heating up. As food
begins to get hot, steam is emitted. When the food reaches a certain temperature and begins to cook, an even
greater amount of steam is released. The increase in steam emission is detected by a humidity sensor in the
oven. This acts as a signal for the oven to calculate how much longer the food needs to reheat. The remaining
cooking time will appear in the display window after two beeps. Whilst the sensor program is still in the display
window the oven door should not be opened. Wait until the cooking time appears in the window, and then open
the door if required, to stir or turn the food.
Adjust to Taste
The "One Push Reheating" reheats a chilled meal for average tastes. You are able to adjust the "One Push
Reheating" to your own taste. After pressing the Dial, “ / “symbol appears in the display,turn Dial clockwise
for more time or anticlockwise for less time. This operation should be completed within 14 seconds. Default
mode is normal.
One Push Reheating
F0003CM40HP_Eng.indd 44F0003CM40HP_Eng.indd 44 2022/9/21 14:02:242022/9/21 14:02:24
To Next Page
Loading...
