- Eng-53 -
English
Cleaning Setting (continued)
F2. System Cleaning
The first stage of this program cleans the system with a citric acid solution. The second stage runs water through
the system to rinse the pipes.
Make a solution of 16 g citric acid and
200 g of water, add the solution to the
water tank. Ensure drip tray is empty.
Tap Cleaning pad
once.
Turn the Dial to select
F2. System Cleaning.
Press the Dial to confirm
the selection.
Press the Dial to start.
The program will run for
approx. 29 minutes.
After the program has paused, empty
the drip tray and fill the water tank
with water (to max level).
Press the Dial to start.
The program will run for approx. 1 minute.
Empty the drip tray after the program has
finished.
Note:
1. When “ “ icon is displayed, run the ‘system cleaning’ program.
2. If the system cleaning program is not used regularly, the pipe will get blocked and the steaming performance
will be less effective.
3. Do not remove the drip tray during the system cleaning program.
4. Empty the drip tray and rinse with running tap water after the program has finished.
F0003CM40HP_Eng.indd 53F0003CM40HP_Eng.indd 53 2022/9/21 14:02:252022/9/21 14:02:25
To Next Page
Loading...
