- Eng-60 -
English
Before Requesting Service (continued)
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in
securely.
Remove plug from outlet, wait 10
seconds and re-insert.
Circuit Breaker or fuse is tripped
or blown.
Contact the specified service Centre.
There is a problem with the
outlet.
Plug another appliance into the outlet
to check if the outlet is working.
Oven will not start
cooking.
The door is not closed
completely.
Close the oven door securely.
Dial was not pressed after
programming.
Press Dial.
Another program has already
been entered into the oven.
Tap Stop/Cancel pad to cancel the
previous program and program again.
The program has not been
entered correctly.
Program again according to the
Operating Instructions.
Stop/Cancel pad has been
tapped accidentally.
Program oven again.
"HOT" appears in the
display window.
The cavity is overheated. Operate again after it cools down.
Only "U14" appears in the
display window.
The water tank is empty.
Full it with water and tap Stop/
Cancel to reset.
"H97" or "H98" or "H00"
appears in the display
window.
This display indicates a problem
with the microwave generation
system.
Contact the authorised service
centre.
“DEMO MODE PRESS
ANY KEY” or “D” appears
in the display window.
The oven is under demonstration
mode.
Tap Micro Power pad once, press
Dial four times then tap Stop/Cancel
pad four times.
The "
" appears in the
Display Window.
The Child Lock was activated
by tapping Stop/Cancel pad 3
times.
Deactivate Lock by tapping Stop/
Cancel pad 3 times.
White powder found at
steam outlet, drip tray and
oven cavity.
The white powder is mineral
crystal from evaporation of
water, it is natural substance and
harmless to human body.
You can use Cleaning setting with
Auto Menu F1&F2 to clean the steam
system and water supply pipe to
improve condition. If crystal attached
to the nozzle or in the oven cavity,
please wipe and clean with a wring
cloth. After using Steam function or
Cleaning, pour out the water from
the drip tray and wipe with a sponge.
If it seems there is a problem with the oven, contact an authorized Service Centre.
F0003CM40HP_Eng.indd 60F0003CM40HP_Eng.indd 60 2022/9/21 14:02:252022/9/21 14:02:25
To Next Page
Loading...
