60
11.7.2. Fan Motor AS’ in PC
1. Remove the Duct PC AS’.
a. Remove 2 screws on the Duct PC AS’.
b. Take out the connector which hides behind the
DUCT PC AS’ and disconnect it.
Figure of after COVER LAMP, COVER LED AG and
PAS-C28VD2 (DEO) are removed.
2. Remove the COVER COIL PC AS. by removing 2
screws and pull the upper edge of the COVER COIL
PC AS. to remove. Be careful not to break the wire, let
the wire go through the hole on the COVER COIL PC
AS. (refer diagram in step 3 below).
Note: At this stage, the PAS-C29FGS (VC) must have
already been removed.
3. Remove the FAN MOTOR AS. in PC compartment.
a. Grab and pull out the HOLDER FAN PC A’SSY. Be
careful not to break the wire, let the wire go
through the top left hole of the HOLDER FAN PC
A’SSY.
b. Push the FAN MOTOR AS. towards the reverse
side of the HOLDER FAN PC A’SSY to release it
from the 2 hooks.
To Next Page
Loading...
