61
11.7.3. Water Valve & HARNESS AS.
11.7.3.1. Water Valve & HARNESS AS.
1. Remove COVER PANEL COMP AS..
• Unscrew 6 screws and lift to remove.
2. Remove the water valve & HARNESS AS.
a. Remove 1 fixation screw.
b. Unscrew the Compression Nut to disconnect the
external water supply hose.
c. Pull the water valve & HARNESS AS. out.
3. Disconnect 4 internal water hoses (2 white, 2 blue).
a. Use a needle nose pliers to remove the clips, then
pull the hoses out.
b. Take out all wires and connector from the storage
box and disconnect the white connector.
11.7.3.2. Water Tank A’ssy
1. Remove the GRIL FRONT and disconnect the white
hose.
a. Remove 2 screws (1 at left end, 1 at right end) on
the GRILLE FRONT (diagram below only shows
the left end screw).
b. Pull off the GRILLE FRONT to reveal the water
hoses.
c. Remove the clips on the white joint.
d. Hold the hose near to the hose sleeve, then pull
the hose out of the joint.
2. Pull out the entire PLATE OZONIZER & FILTER
(together with the hoses that attached to FILTER AS.
holder) to reveal the TANK beneath it.
3. Remove the COVER TANK.
4. Remove the TANK.
a. Remove a fixation screw on the TANK.
b. Remove the TANK by pulling it out together with
the hoses attached to it.
To Next Page
Loading...
