Panasonic NR-B53VW2 - DOOR AS. PC, PCB (Door PC); Hinge Bottom, Adjuster Bolt

63
11.8.2. DOOR AS. PC, PCB (Door PC)
1. Open the COVER HINGE TOP (R) by removing 2
screws and pulling it upwards.
2. Remove the PCB (Door PC).
a. Slide the PCB (Door PC) Holder out of the Top
Hinge Cover (R).
b. Slide out the PCB (Door PC) from its holder and
disconnect its connector to remove.
3. Remove DOOR AS. PC.
a. Disconnect the wire connector.
b. Remove 3 hex screws.
c. Lift the Top Hinge (R) to remove.
d. Lift the DOOR AS. PC off the Bottom Hinge (R) to
remove.
NOTE
When removing the HINGE TOP, be careful that the door
does not fall forward.
11.8.3. Hinge Bottom, Adjuster Bolt
1. Remove the right HINGE BOTTOM and Adjuster Bolt.
a. Remove 1 screw on the HINGE BOTTOM (R).
b. Remove 3 Hex Screws to remove the HINGE
BOTTOM (R).
c. Unscrew the Adjuster Bolt to remove.
2. Remove the left HINGE BOTTOM and Adjuster Bolt
the same way as for right side.