- Eng-47 -
English
Before Requesting Service
PROBLEM POSSIBLE CAUSE 5(0('<
No display on panel.
The oven is not plugged in securely.
Remove plug from outlet, wait 10 seconds
and re-insert.
Circuit breaker or fuse is tripped
or blown.
Reinstall the fuse or reset the circuit
breaker.
There is a problem with the outlet.
Plug another appliance into the outlet to
check if the outlet is working.
Oven cannot start
operation.
The door is not closed completely.
Close the oven door securely.
Start/Set button was not
pressed after programming.
Press Start/Set button.
Another program has already
been entered into the oven.
Press Stop/Reset button to cancel the
previous program and program again.
The program has not been
entered correctly.
Program again according to the operating
instructions.
Stop/Reset button has been
pressed accidentally.
Program oven again.
No steam
Check whether the water tank
has water.
Fully fill the water tank and properly install it.
Check whether the integrated water
tank is installed correctly in place.
“U14” appears in the
display window.
The water tank lacks water.
Even it is full of water, “U14” will
appears in the display window in
different conditions.
“U14” appears in the first two cooking
stages, you can refill water and press
Start/Set button to continue. It is not
available if “U14” appears in the third
time. Please fill the water tank with water
again. Replace to the oven and press
Stop/Reset to reset.
If it is not cleaned in time after “ ”
appears in the display window, scale
will accumulate around the inner
wall of the water-piping.
Please use the citric acid cleaning function
to clean the water-piping.
“H00” appears in the
display window.
There is a problem with the oven.
Please contact the service center specified
by Panasonic.
To Next Page
Loading...
