the power is switched off and on again. (Once the Battery is
removed or dead, Error No. will not remain in the memory.)
6.1.3. REMOVAL/INSTALLATION OF F.P.C. FROM NON ZIF (Zero Insertion
Force) CONNECTOR
Removal/Installation of F.P.C. from the Non ZIF (Zero Insertion Force) connector:
1. The Non ZIF connectors and the ZIF connectors are used on the
unit. And there are 2 types (Type A, Type B) of Non ZIF
connectors.
2. To remove the F.P.C. from the Non ZIF connector, use the Plier for
Non ZIF Connector (LSVQ0028) to pull out the F.P.C. as shown.
The same Plier for Non ZIF Connector (LSVQ0028) should also be
used to install the F.P.C. to the Non ZIF Connector.
Fig. 3-1
3. Connect the F.P.C.s to the Non ZIF connectors, verifying the
direction of F.P.C as shown.
Fig. 3-2
12
To Next Page
Loading...
