6. SERVICE NOTES (PLEASE READ)
6.1. SERVICE NOTES
6.1.1. EXTENSION CABLES FOR SERVICE POSITION
Using the following Extension Cables, place the unit as shown for check and service.
Extension Cables (No.5 ~ No.8) are used for improving serviceability. (They are not necessarily
used.)
Note :
1. The LCD open/close SW. is for changing between LCD Display or
EVF Display. When turning on LCD Display, place some paper or
tape, etc. on LCD open/close SW. so that this SW. stays ON.
2. Connect the F.P.C.s to the connectors, verifying the direction of
F.P.C. as shown.
3. Use a grounded ESD wrist strap while disassembling the Lens
9
To Next Page
Loading...
