2. Connect the oscilloscope to "Envelope TP" on the Measuring
Board.
3. Playback the Tape Path Alignment Tape (LSVQ0041).
4. Adjust the S1 post by turning the top of post with Post Height
Adjustment Fixture (LSVQ0021) so that the left half of envelope
signal becomes flat as possible.
5. Adjust the T1 post by turning the top of post with Post Height
Adjustment Fixture (LSVQ0021) so that the right half of envelope
signal becomes flat as possible.
8.3. ELECTRICAL ADJUSTMENT
8.3.1. INITIAL GUIDELINE
The table below shows which adjustments are necessary according to the unit parts and
individual parts to be replaced. Make sure to perform these adjustments shown below as
necessary.
60
To Next Page
Loading...
