Panasonic Omnivision PV-9401 - Page 13

*Important: If the remote contro
TAPE POSITION, or ADD/DLT button does not work when Ded. press the VCR button on the
remote and try the button again.
End the program.
1) Press PROG
(or ACTION).
To Enter More Programs
Press AV to select, and ® to display
a blank program number. Then
repeat steps 3 and 4.
2) Press PROG (or
i DT START STOP CH SPD
8 10:00P 12: lis Sa
EEN me a5
J we tio io
CANCEL :ADD/DLT KEY
SELECT 1-8:4 v KEY
ENTER :b KEY
END :PROG/ACTION KEY
ACTION) again to exit.
Set the timer.
Press Power OFF.
+ When recording
programs via a cable
box, make sure the
cable box is left ON
and tuned to the
desired channel.
Multi Function Display
Review, Replace or Clear Program Contents:
(Recording is not in progress)
Repeat steps 1~2 on page 12.
« If necessary, press POWER ON.
Select program.
1) Press AY to
select number.
P_DT_START STOP CH _ SPD
CANCEL: ADD/DLT KEY
SELECT 1-8:4 ¥ KEY
C To Replace program...
DATE START___STOP___ CH
8 SAT 10:00P 12: OOF 125
ODAY\
CATEGORY : MOVIE
NOTES: STAND BY ME
SELECT START DATE
SELECT: Y KEY
SET ¡4 > KEY
1) Press » to display.
2) Press AV «> to
set new program
contents.
To Clear program...
P DT START STOP CH SPD 1) Press ADD/DLT.
ADD/DLT
2 8 10:00P 12: OOP 125 SP
3 10 8:00P 9:00P 10 SP
4 SU 9:00P40:00P Li LP
SELECT 1-8:4 v KEY
ENTER :p KEY
End the program.
1) Press PROG (or ACTION) .
e If there are programs, press
POWER OFF.
d
To cance! Timer Recording
(Recording is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (The TIMER
indicator goes out on Multi
Function Display.)
Multi Function Display
SELECT/
ADD/
C DELETE
Model PV-9451 remote is shown here.
13
=
3
0
=
po
0
O
e]
—
2.
=
Q