Panasonic Omnivision PV-9401 - VCR & Cassette Information; Reset All VCR Memory Functions

VCR & Cassette Information
Reset All VCR Memory Functions
Use when moving VCR to new location, or if a mistake was
made in the One Time VCR Setup section.
* Make sure a tape is not inserted in the VCR.
Model PV-9451 VCR is shown here.
Power on.
2 Press and hold both PLAY
and CHANNEL A on the VCR
for more than 5 seconds.
¢ The power will shut off.
3 Do “One Time VCR Setup” steps on page 6.
DST (Daylight Saving Time)
VCR auto adjusts clock for DST. (Page 7.)
Spring (First Sunday in April)
DST:ON --> sets clock ahead one hour.
NORMAL TIME 1:00 a.m. Eno, a.m.
DAYLIGHT :
SAVING TIME 3:00 a.m. 4:00 a.m.
Autumn (Last Sunday in October)
DST:ON --> Turns clock back one hour.
DAYLIGHT 1:00 a.m. 2:00 a.m.
SAVING TIME :
NORMAL TIME
:
A
1:00 a.m. 2:00 a.m.
* If your area does not observe Daylight Saving
Time, select DST:OFF.
* Keep these time changes in mind when
programming the VCR for timer recordings.
4
Ud
Prevent Accidental Tape Erasure
Break off the tab.
Tab
Screw driver WN
To record again
Cover the hole
with cellophane tape.
Record/Playback Time
Only use tapes with the mark in this unit.
Tape Speed Type of Video Cassette
Setting T60 T120 T160
SP 2 Hours
4 Hours 5 Hours
3 Hours 6 Hours 8 Hours
LP
(Long Play)
SLP
(Super Long Play)
For assistance, call 1-800-211-PANA(7262).