Panasonic Omnivision PV-9401 - Page 17

“Important: If the remote control POWER, A yS,
TAPE POSITION, or ADD/DLT button does not work when pressed, press the VCR button on the
remote and try the button again.
(A check list before you begin.
C) The clock is set.
C] VCR Plus+ System Setup is complete (see pages 14~16).
Display SET PROGRAM.
Press PROG.
2 Display VCR Plus+
screen.
1) Press AV
TIMER PROGRAM to select.
2) Press >
SELECT:á Y KEY a
SET i> KEY to display.
END :PROG KEY
Enter PlusCode
programming number.
OOGO) t}Press
© Numbered
VCR Plus+
ENTER PLUSCODE NUMBER
A #
E |
USING 0-9 KEYS keys.
2) Press PROG
To make corrections, to lock in the
press <q repeatedly to delete the program.
PlusCode programming number.
Enter record frequency.
3) Press 1, 2, or
3 key to select
program type.
VCR Plus+
1 ONE TIME
2 DAILY (M N-FAI)
3 WEEKL QOO®
TO SELECT PUSH 1,2 OR 3
Select Category.**
1) Press av to
change.
2) Press > set.
DATE START STOP___CH
8 SAT 10: OOF 12:00P 125
KE
CATEGORY: N , A
Japo
SELECT CATEGORY
SELECT:a Y KEY
SET ¿4 > KEY
END :PROG/ACTION KEY Change record speed.
Repeat 1) and 2).
Make notes. -----> Do step 4 on page 12.
* If not wanted, go to step 6.
End programming.
P DT START STOP CH SPD
6
1DAY
9:00A12:00A
08
SP
1)
Press
PROG
2 8 10:00P12:00P 125 SP
3
Sos (or ACTION).
A
To
cancel
CANCEL : ADD/DLT KEY press ADD/DLT.
ENTER EN 2) Press PROG
END :PROG/ACTION KEY (or ACTION) |
again to exit.
Set timer.
Multi Function Display
Press Power OFF.
Process of Recording
Conecton|->|Seup|-> SES
T POWER
2 SELECT/
~ SET
6 ACTION
¡MEA
NUMBERED
S
keys
ws
ADD/
E)
DELETE
Model PV-9451 remote is shown here.
** Category Items
N/A(not applicable), SPORTS,
MOVIE, COMEDY, MUSIC, DRAMA
Use normal Timer Recording steps if:
+ the PlusCode programming number for a
program is not listed.
* you anticipate the program, such as a
sporting event, to run over the scheduled
stop time.
See page 13 to:
* cancel a timer recording in progress.
* replace program contents.
e review or clear program contents once set.
Important notes for DSS/Cable Box users
e When recording via DSS, the receiver,
must be left on.
e When recording via cable or antenna,
DSS receiver must be off.
* Avoid overlapping program times.
+ VCR PlusCode programming numbers
can not be used to program the VCR to
record DSS channels.
* You can obtain unlisted PlusCode
numbers by calling 1 - 900 - 454 - 7587.
Call costs approximately $.95 per minute.
17
twajsÁs +snid HOA Buisn Bulpsooay seu